If you want to strengthen your floor pan and drive shaft tunnel in your 5th Gen Camaro, check out this Driveshaft Tunnel Brace from BMR Fabrication. This brace will replace the factory component and uses the factory mounting holes for smooth installation. It only takes less than an hour to install, and it is well worth that little time.
Official Release BMR Fabrication Driveshaft Tunnel Brace for the 2010 Camaro 
Strengthen the floor pan and drive shaft tunnel in your 5th Gen Camaro with a Driveshaft Tunnel Brace from BMR Fabrication. Constructed from 1” x 2” x .083 wall rectangular steel and 3/16” CNC laser cut steel plates, these braces replace the factory stamped steel design. The BMR Driveshaft Tunnel Brace (DTB004) uses factory mounting holes while increasing the rigidity of the tunnel in the critical area where the driveshaft carrier bearing is located. When used with the BMR Sub Frame Connectors, the Driveshaft Tunnel Brace ties the driver side and the passenger side together into a sturdy crossbrace. Installation time is less than 1 hour. Available in black hammertone or red powdercoat finishes.
Contact Information BMR Fabrication
Web:
www.bmrfabrication.com
Phone: 813-986-9302
Linear Mode
